Help sourcing parts

[mdshunk]

If somebody could help me with sourcing the parts highlighted in the chart below for my Ridgid 4P-J geared threader (aka "hog head threader"), I'd be pleased. My local plumbing supply house said, even after I provided the Ridgid part numbers, "Sorry- not in our system." I ain't coming up with squat online.

Thanks... Marc.

[Marksix]

Here is one place I found that lists them as available:

https://production.ecom.brocktool.com/xephr/qbe/RIDGID_ONLINE

Look under "Dies and Cutter wheels",then select "dies"

[mdshunk]

Hey, thanks for that link. I don't think that the prices are right on that site, though. If they were true, it would take almost $900 dollars worth of dies for my threader, which I know isn't true. I'll have to give those folks a ring.

[xkvator]

MD
a pipefitter i work with has a big threader...I had him thread some 4" for me about 2 yrs. ago...I'll ask him this evening.
the dies for the smaller threader...2" & under are about $100/set & the newer adjustable head set 2 1/2 - 4" are about $225 @ Grainger, so the $900 might be what 4 sets would be.

[mdshunk]

XK... why do you have a picture of me as your avatar? That's a little bit gay.

Anyhow, 900 bucks can't be right, because they aren't "dies" per se. They are just a few sets of little teeth on the end of a bar that you load into the threader. You can hold all of them in one hand with room to spare. If they are 900 bucks, I'll continue to use my dull ones until they won't work anymore.