Lennox Furnace G16R Series- NO HEAT!! HELP!!

[Kham]

Hello out there!!!

Ok, i am new so it took me some time to post this...but my problem is. I need heat in my house. All my wiring is correct for the thermostat i have which, is a RiteTemp 8050c, and my heat is still not kicking in. I didn't have cool air for the summer so i got a tech to come and check it out and now i don't have heat for the winter. I just want to be able to transition from heat to air or visa versa when i need to and have to bring a tech out diggin' in my pockets. Can anyone out there help me.

I have turn off my Gas and the thermostat and my mom wired the up the white wire to W2 on the thermostat and the furnace has a W1 and T2 that has no wires connected. I hope that i have explain my situation ok for someone to understand. Thank, I will be checking for a response periodically because me and my family are COLD!! (still smiling)

Mr. T you seem to be a veteran and expert in this type of situation/business. I hope that you can help. thanks!

Anyone help PLEASE! (10:07pm-10/27/07)

[Mr T]

fyi, you are posting in the test room..

I am just a hobbiest. There are quite a few furnace pros on here, so wait for their responses too. :bootyshake:

W2 is for a heatpump. If you do not have a heat pump and it sounds like you dont, you need your white wire to the W terminal.

If the above doesnt work, what color wires do you have? (or what are they labeld as)

[Kham]

actually I do have a heat pump and we had the wire on the W2 terminal and now we put it back onto the W terminal sir, but i am thinking that it's a problem with the furnace wiring.

I am trying to firgue out which is for the heat.

the gas pipe line switches are facing down, i have two of them on one pipe line.

I had called the lennox customer service and the representative said that the tech that came out, probably did not rewire to the terminal for heat.

what do you think?

[Mr T]

Do you have anything on the W terminal?
What wires do you have?

Did you just install this thermostat?

[Kham]

No sir, the thermostat was installed during the summer around june i believe. the white wire is hooked to the W terminal on the thermostat....but when I to look at the furnace....there is a white wire that is not hooked up. I am look on the left side of my furnace and these wires are in place with where the transformer is.

wiring diagram for the lennox accessories FMP3-1,

it has a termial strip of V,W1,X,T1 and T2
another termial strip of 1,2,3,4,5,6,7,8,9 and 10
defrost relay section , time delay relay section
transform,er
heat relay section
wires orange-240v, red-208v,white-120v,black-common and blue to V of thermostat.

I wish I had a picture to attached to send you, but i don't....so i hope this helps.

[Mr T]

The white wire is your signal for heat. It needs hooked up to W or W1 on your furnace.. Make sure that wire is coming from the W terminal on your thermostat.

Pictures would be very helpful